Motorola V180/V186 Faceplate Installation Instructions

Installing your new faceplate or housing onto your Motorola V180 is quick and simple when you follow these steps. Please remember that a T6 Torx Screwdriver is required for this installation. Use of a tool other than a T6 Torx Screwdriver to remove your faceplate may result in damage to the faceplate or to your phone.

Step 1:
Use a pin or small flat-head to pop up the middle piece of the front cover

Step 2:
Remove the middle piece to expose (4) T6 screws

Step 3:
Remove the Torx screws with the T6 Screwdriver

Step 4:
Carefully slide off the cover

Step 5:
Re-Install your new faceplate in the reverse order.

Step 6:
Replace back battery cover

* Please note that these instructions are provided as a guide only and under the assumption that you are familiar with taking your phone apart. We are not responsible for damage caused from improperly removed or replaced faceplates and phone covers. If you do not feel comfortable replacing the cover on your own, please take it to a professional installer.